| To
fit, gun adhesive onto the back of the main ogee skirting
profile and push over existing board. Internal and
external corner covers are available so there is no
need to mitre the main board, however you will need
to notch one of the boards where they meet in a corner
(as picture).
Once all of the
main boards are in place, fit the corner and joint
covers with double sided tape provided.
The ogee top moulding
should then be stuck onto the top of the main skirting
board, again using the double sided tape supplied.
This top moulding will cover any gap between the skirting
and the wall and will complete the skirting board
detail. You will need to mitre the ogee quadrant and
file or cut the bottom of the quadrant where it runs
over the corners and joints our mitre shears are ideal
for this job. Finally fill any gap between the quadrant
and the wall if necessary with our decorators caulk.
You can also use the caulk to seal any imperfect mitres
in the quadrant although a smear of white silicone
(available at an extra cost) would be better. |
